[cvsnt] Re: couldn't connect to server

[Bernhard Mayer]

i'm using winxp pro sp1 and the windows firewall is disabled. zonealarm as
firewall and cvslock and cvsservice have full access. nod32 as virusscanner
but no alert or something.
all other apps runs normaly, only cvs didn't.

the sspi_protocoll.dll is in the cvs folder.


"Bo Berglund" <Bo.Berglund at system3r.se> schrieb im Newsbeitrag
news:mailman.231.1087284966.378.cvsnt at cvsnt.org...
Now,
this sounds like a networking, firewalling or AntiVirus issue to me.

What operating system do you run on the PC?
If you have XP-Home there might be problems with the way networking is
implemented.
If you have XP-Pro and a later service pack then you might have the Internet
Firewall enabled and this blocks access to the 2401 port, I believe.
If you have AntiVirus software running it might also block server access, it
depends on the type of AV software.

And, the default WinCvs and CVSNT installations include all that is needed
for sspi communication to work. You can check if you have the
sspi_protocol.dll file in the folder where the cvs binaries are located.
There is nothing to "set" to make it work.

/Bo

-----Original Message-----
From: cvsnt-bounces at cvsnt.org [mailto:cvsnt-bounces at cvsnt.org]On Behalf
Of Bernhard Mayer
Sent: den 15 juni 2004 08:52
To: cvsnt at cvsnt.org
Subject: [cvsnt] Re: couldn't connect to server


after tried to list it got this error
cvs [ls aborted]: Can't authenticate - server and client cannot agree on an
authentication scheme (got '')

do i have to set something in cvs to work with sspi?


"Bo Berglund" <bo.berglund at telia.com> schrieb im Newsbeitrag
news:toqrc0tkrd5pdih4d1n9gf557poc4b1n31 at 4ax.com...
> On Mon, 14 Jun 2004 11:23:41 +0200, "Bernhard Mayer"
> <mayerbernd at gmx.net> wrote:
>
> >ok, tried with sspi but than i get this error:
> >cvs [login aborted]: Can't authenticate - server and client cannot agree
on
> >an authentication scheme (got '')
> >
> >now i have set the repository settings as follow:
> >prefix: d:/cvs
> >repository: /repository
> >
> >tried to connect with this:
> >cvs -d :pserver:user at localhost:/repository login
> >or
> >cvs -d :sspi:mckenna at localhost:/repository login
>
> Wrong, should be:
> cvs -d :sspi:localhost:/repository ls -l
>
> or some other cvs command. Do not enter login.
>
> Please note that the login is *only* used with :pserver: (always) and
> :sspi: if you specify a user. Without a specified user :sspi: uses the
> Windows login you have already done when you started the workstation.
> This is what simplifies matters. So please test without the user and
> without login.
>
>
>
> /Bo
> (Bo Berglund, developer in Sweden)

_______________________________________________
cvsnt mailing list
cvsnt at cvsnt.org
http://www.cvsnt.org/cgi-bin/mailman/listinfo/cvsnt