[cvsnt] Re: Viewcvs

[Dan Pupek]

The new version install did the trick. The diagnostic settings never
actually exposed any additional information so I am not sure why it stopped
working.

Thanks for the help!

------------------------------------
Advanced Systems Technology, Inc
Dan Pupek
Lead Software Engineer
dan-pupek at dcmsnet.info
8130 Pitman Ave.
Pensacola, Florida 32534
tel: 850-475-4038
fax: 850-473-8387
mobile: 850-529-0055
------------------------------------


-----Original Message-----
From: cvsnt-bounces at cvsnt.org [mailto:cvsnt-bounces at cvsnt.org]On Behalf
Of Bo Berglund
Sent: Thursday, January 05, 2006 8:56 AM
To: cvsnt at cvsnt.org
Subject: [cvsnt] Re: Viewcvs


On Wed, 4 Jan 2006 19:25:08 -0600, "Dan Pupek" <dpupek at astpcola.com>
wrote:

>Thanks, and I know the question was a bit thin but I typed it in
>as I was heading out. My CVSNT version is 2.5.03.2151 and I just
>upgraded yesterday.
>My viewcvs version is the one you provide on your site (rev o).
>Up until the upgrade of CVSNT everything worked fine (with viewcvs).
>In fact it has been so long I had forgotten about the diagnostic
>options.
>
>Let me try to debug it some and apply the CvsGraph fix.

(Please do not reply to my private email...)

If you have used my ViewCvs installer version and CVSNTversion 2.0.xx
then the best procedure after upgrading CVSNT is to:
1) ControlPanel/AddRemove: Uninstall the ViewCvs installation
2) Download the latest ViewCvs installer (I posted a new one today)
3) Run the installer

For all but very strange configurations you should be fine with a
working ViewCvs system at this point.
If you have done some special tricks to your configuration you could
save the X.conf files before uninstalling and then after reinstall you
can compare the new conf files with the old saved ones and modify as
needed.


/Bo
(Bo Berglund, developer in Sweden)
_______________________________________________
cvsnt mailing list
cvsnt at cvsnt.org
http://www.cvsnt.org/cgi-bin/mailman/listinfo/cvsnt