[cvsnt] CVSNT Control Panel not working

[Bo Berglund]

On Tue, 30 May 2006 23:01:13 +0100, Tony Hoyle
<tony.hoyle at march-hare.com> wrote:

>Bo Berglund wrote:
>> Once upon a time this file was registered as the control panel app,
>> but then it stopped working and I changed the inno installer to
>> register cvsnt.cpl instead and immediately I had the cp there all the
>> time.
>>
>You must use simcpl as the control panel app - if that isn't working the 
>innosetup installer is doing something wrong... it's not surprising that 
>the cvsnt.cpl won't start up in that kind of configuration.

It does not for this one single installation. In all of mine and a
number of othrs there are no reports of failures.
This poster also says that starting simcpl.cpl does no good, no change
and no panel.

>simcpl is required to let the control panel pick up its runtime 
>dependencies.  If that isn't working then the control panel won't work 
>either.

Not my experience....Seems to work fine through cvsnt.cpl.

So what is needed?
1) put simcpl.cpl into the registry
2) create shortcut to simcpl.cpl instead ov cvsnt.cpl
???

HTH

/Bo
(Bo Berglund, developer in Sweden)