UD6 2.1.05 is the current production release as of October 2013. It incorporates many refinements suggested by customers since the release of UD6 1.03, and continues support for the latest releases of Uniface and SCM/CM tools.
More details are available in the Whats new in UD6 2.1.05 page.
UD6 2.1 has different default settings than UD6 1.03 so it may be necessary to alter the USYS$UD6_PARAMS in your ASN file to ensure that UD6 2.1 behaves similar to UD6 1.03. Refer to the ASN Settings for Upgrading for details.
If you are using the UD6 Option Pack and intend to use the MAKE / Buld Management features then it will be necessary to check out all forms and compile them to create the initial Makefile. You can use the USYS$UD6_PARAMS=makefiles setting to specify various options.
There are two migration paths for moving your source code from earlier versions of UD6:
March Hare strongly recommend migrating your existing setup and functionality - not the new features, unless one of the new features is particularly helpful for your installation.
Please refer to the following articles
Microsoft Internet Explorer version 5 and higher can be used to display the formatted contents of the XML source files. This uses the MSXML software.
Microsoft have advised that all customers should upgrade their MSXML software due to security concerns. Full details are available from the Microsoft web site: http://www.microsoft.com/technet/treeview/default.asp?url=/technet/security/bulletin/MS02-008.asp.
Read more about Uniface Version Control
|$Revision: 1.15 $ $Date: 2014/05/06 10:12:57 $||[go to top]|